Planet Audio Pro MB2200.5D 2200W High Output 5 Channel Full Range Class D Amplifier (Black)

The Planet Audio Pro MB2200.5D 2200W High Output 5 Channel Full Range Class D Amplifier in Black offers full-range Class D, MOSFET power supply. It has high- and low-level inputs, Variable High Pass Crossover, Variable Low Pass Crossover, and Variable Bass Boost. It is accompanied by a remote subwoofer control.
2 Ohm Stable
The lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms. Class D Amps Class D is a high-speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A and B amps. Planet Audio uses Class D in the monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass.
High- and Low-Level Inputs
An amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit.
Protection
If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.
Subwoofer Level Control and Switchable Input Sensitivity
Subwoofer Level Control is the ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output. Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.
Variable Controls and Filters
Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it. Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. Too much gain will lead to distortion and to little will lead to clipping. Variable high-pass filter gives you control over the frequencies that pass through to the full range speakers. Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.