EarthQuaker Devices Blumes Low Signal Shredder Overdrive Pedal for Bass (Water Blue)

The EarthQuaker Devices Blumes is an all-analog tri-mode soft-clipping bass overdrive that carries the torch of the classic screamer circuit but has a voice all its own. While embodying most of the characteristics and features of the beloved Plumes Small Signal Shredder, this modified circuit has double the gain and a deeper bass response to retain all the low ends. It utilizes internal bipolar power, which gives you more dynamics and all the headroom you could ever desire. The result is a three-dimensional tone with added clarity that pushes a nice tube amp over the edge.
Design Notes
As a bass player, EarthQuaker understands that you often feel neglected within the hierarchy of band constructs, even though you hold down the rhythmic foundation and make everyone sound better. So that’s why this marvelous yellow box was created specifically for you. But fear not, 6-stringers, this is also the perfect pedal for all of your deep overdrive needs, especially you drop-tuned masters. This all-analog tri-mode overdrive with soft clipping carries the torch of the classic screamer circuit but has a voice all its own. While embodying most of the kick-ass characteristics and features of the Plumes, EarthQuaker Devices went ahead and modified this circuit with double the gain and a deeper bass response to retain the entire low end. At lower gain settings, you’ll get all of the crunchy tones you love about the original, but once you get above noon on the Gain control, that’s where the similarities stop. Get ready to shake some walls and field some angry calls from your neighbors (just send them to voicemail).
Clipping Options
And much like the Plumes, this pedal offers three different clipping options for your desired low-end face melting needs. Mode 1 is a symmetrical LED clipping that utilizes a pair of light-emitting diodes. This is the crunchiest setting the Blumes has to offer. This signal is less compressed and way more open with tons of output for when you really want to go wild. Mode 2 is a clean pure OpAmp gain boost mode. This eliminates the soft clipping diodes and leaves you with a straight OpAmp drive. This will be the loudest output with the fullest frequency response and can be used as a clean boost when the Gain control is set below 11 O’clock. Mode 3 is an asymmetrical silicon diode arrangement similar to the stock screamer but with more output and clean clarity, which provides a more transparent tone. Using this mode gives a warmer low-end response and lower output. It’s fuzzier with half the output and is the most compressed. If you like the fuzzy ends of distortion with a clean undertone, you’ll love this setting. EarthQuaker guarantees it.